Installing the API behind mod_wsgi

Cloudkitty comes with a few example files for configuring the API service to run behind Apache with mod_wsgi.

app.wsgi

The file cloudkitty/api/app.wsgi sets up the V1 API WSGI application. The file needs to be copied to /var/www/cloudkitty/, and should not need to be modified.

etc/apache2/cloudkitty

The etc/apache2/cloudkitty file contains example settings that work with a copy of cloudkitty installed via devstack.

# Copyright (c) 2013 New Dream Network, LLC (DreamHost)
#
# Licensed under the Apache License, Version 2.0 (the "License"); you may
# not use this file except in compliance with the License. You may obtain
# a copy of the License at
#
#      http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS, WITHOUT
# WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the
# License for the specific language governing permissions and limitations
# under the License.

# This is an example Apache2 configuration file for using the
# cloudkitty API through mod_wsgi.

# Note: If you are using a Debian-based system then the paths
# "/var/log/httpd" and "/var/run/httpd" will use "apache2" instead
# of "httpd".
#
# The number of processes and threads is an example only and should
# be adjusted according to local requirements.

Listen 8889

<VirtualHost *:8889>
    WSGIDaemonProcess cloudkitty-api processes=2 threads=10 user=SOMEUSER display-name=%{GROUP}
    WSGIProcessGroup cloudkitty-api
    WSGIScriptAlias / /var/www/cloudkitty/app.wsgi
    WSGIApplicationGroup %{GLOBAL}
    <IfVersion >= 2.4>
        ErrorLogFormat "%{cu}t %M"
    </IfVersion>
    ErrorLog /var/log/httpd/cloudkitty_error.log
    CustomLog /var/log/httpd/cloudkitty_access.log combined
</VirtualHost>

WSGISocketPrefix /var/run/httpd
  1. On deb-based systems copy or symlink the file to /etc/apache2/sites-available. For rpm-based systems the file will go in /etc/httpd/conf.d.

  2. Modify the WSGIDaemonProcess directive to set the user and group values to an appropriate user on your server. In many installations cloudkitty will be correct.

  3. Enable the cloudkitty site. On deb-based systems:

    # a2ensite cloudkitty
    # service apache2 reload
    

    On rpm-based systems:

    # service httpd reload