Configuring IPMI support

Installing ipmitool command

To enable one of the drivers that use IPMI protocol for power and management actions (for example, ipmi), the ipmitool command must be present on the service node(s) where ironic-conductor is running. On most distros, it is provided as part of the ipmitool package. Source code is available at http://ipmitool.sourceforge.net/.

Warning

Certain distros, notably Mac OS X and SLES, install openipmi instead of ipmitool by default. This driver is not compatible with openipmi as it relies on error handling options not provided by this tool.

Please refer to the IPMI driver for information on how to configure and use IPMItool-based drivers.

Configuring hardware

IPMI is a relatively old protocol and may require additional set up on the hardware side that the Bare Metal service cannot do automatically:

  1. Make sure IPMI is enabled and the account you use have the permissions to change power and boot devices. By default the administrator rights are expected, you can change it: see Using a different privilege level.

  2. Make sure the cipher suites are configured for maximum security. Suite 17 is recommended, 3 can be used if it’s not available. Cipher suite 0 must be disabled as it provides unauthenticated access to the BMC.

    See also

    Cipher suites

  3. Make sure the boot mode correspond to the expected boot mode on the node (see Boot mode support). Some hardware is able to change the boot mode to the requested by Ironic, some does not.

Validation and troubleshooting

Check that you can connect to, and authenticate with, the IPMI controller in your bare metal server by running ipmitool:

ipmitool -I lanplus -H <ip-address> -U <username> -P <password> chassis power status

where <ip-address> is the IP of the IPMI controller you want to access. This is not the bare metal node’s main IP. The IPMI controller should have its own unique IP.

If the above command doesn’t return the power status of the bare metal server, check that

  • ipmitool is installed and is available via the $PATH environment variable.

  • The IPMI controller on your bare metal server is turned on.

  • The IPMI controller credentials and IP address passed in the command are correct.

  • The conductor node has a route to the IPMI controller. This can be checked by just pinging the IPMI controller IP from the conductor node.

IPMI configuration

If there are slow or unresponsive BMCs in the environment, the min_command_interval configuration option in the [ipmi] section may need to be raised. The default is fairly conservative, as setting this timeout too low can cause older BMCs to crash and require a hard-reset.

Collecting sensor data

Bare Metal service supports sending IPMI sensor data to Telemetry with certain hardware types, such as ipmi, ilo and irmc. By default, support for sending IPMI sensor data to Telemetry is disabled. If you want to enable it, you should make the following two changes in ironic.conf:

[conductor]
send_sensor_data = true
[oslo_messaging_notifications]
driver = messagingv2

If you want to customize the sensor types which will be sent to Telemetry, change the send_sensor_data_types option. For example, the below settings will send information about temperature, fan, voltage from sensors to the Telemetry service:

send_sensor_data_types=Temperature,Fan,Voltage

Supported sensor types are defined by the Telemetry service, currently these are Temperature, Fan, Voltage, Current. Special value All (the default) designates all supported sensor types.